DocuSign Insight - How to change ATN Import location?

Open '%seal_home%\config\seal\seal-back\application.conf' and scroll down to the import-section (line 208). There are "#" symbols in front of each line that must be removed. In addition, you're going to need to change the location.

#import {
# location = "${seal.home}/data/import"
# fileSizeLimit = 25.0

# Creates and exports a DOCX file. NOTE: setting this flag
# to true will send a DOCX version of the extracted document
# for processing instead of the original.
# createdocx = false
#}

When changing the location, you must ensure it is shared, and permissions have been setup to allow ScD and the importer to properly access it. Also please note that the closing bracket needs to be uncommented as well as seen in the example below. The filesize does not need to be, only if you intend to change the file size limit.

Example:

import {
location = "\\\\10.71.0.4\\ATNImport"
fileSizeLimit = 125.0

# Creates and exports a DOCX file. NOTE: setting this flag
# to true will send a DOCX version of the extracted document
# for processing instead of the original.
# createdocx = false
}